Setting Up the Hardware

Before setting up the hardware, consider the most effective location for a communications base.

You must perform these steps to set up the hardware:

1.  Set up the communications base.

a. To use Dynamic or Static IP, connect the Ethernet cable to the base.  To use dial as default (note that only one terminal can be registered to a base), connect the dial cable.

b. Connect the power cable to the communications base.  (If multiple terminals will be registered to one base, connect the power cable to the other terminals' bases.)

2.  Install the paper roll.

3.  Charge the terminal battery.

4.  Register the terminal to the communications base.

 

Go back to "Getting Started."