Configuring Dynamic Public IP Communication

If your terminal is registered to a base that will communicate with the Moneris Host over the Internet using public IP with dynamic addressing, you will need to set up these parameters for the base.

To navigate through the menus:

- Scroll down: press
the key_f1-r.jpg key to move the highlight bar down.
- Scroll up: press
the key_f3-r.jpg key to move the highlight bar up.
- Select a
highlighted item: press the key_okay-r.jpg  key.

For information about the keys...

1.  Follow one of the procedures below:

If terminal has NEVER been initialized:

If terminal has already been initialized:

From the TERMINAL SETUP REQUIRED screen:

a.  Press the key_admin-r.jpg  key.
The MAIN MENU appears.

b.  Scroll down to CONFIGURATION, and press the key_okay-r.jpg  key.
The CONFIG FUNCS menu appears.

c.  Scroll down to GENERAL PARAMS, and press the key_okay-r.jpg  key.

If the SWIPE ADMIN CARD prompt appears, swipe the POS Admin card.

The GENERAL PARAMETERS menu appears.

d.  Press the key_okay-r.jpg  key to select COMMS TYPE.
The COMMUNICATION TYPE menu appears.

e.  Scroll to ETHERNET, and press the key_okay-r.jpg  key.
The BASE IP SETUP menu appears.

f. Go to step 2 below.

From the READY screen:

a. Set the COMMS TYPE parameter as ETHERNET.   

b. Set the HOST SETUP parameter as PUBLIC.

c.  Set the ETHERNET TYPE parameter as DYNAMIC:

i.  Press the key_admin-r.jpg  key.
The MAIN MENU appears.

ii.  Scroll down to CONFIGURATION, and press the key_okay-r.jpg  key.
The CONFIG FUNCS menu appears.

iii.  Scroll down to BASE CONFIG, and press the key_okay-r.jpg  key.

If the SWIPE ADMIN CARD prompt appears, swipe the POS Admin card.

The BASE CONFIG menu appears.

iv. Scroll down to BASE IP SETUP, and press the key_okay-r.jpg  key. The BASE IP SETUP menu appears.

v.  Press the key_okay-r.jpg  key to select ETHERNET SETUP.

vi.  Press the key_okay-r.jpg  key to select ETHERNET SETUP.

vii.  Scroll down to DYNAMIC, and press the key_okay-r.jpg  key.

viii.  Press the key_cancel.jpg key once.
The BASE IP SETUP menu appears.

d. Go to step 2 below.

 

2. Test the terminal's connectivity to the Moneris Host:

a. From the BASE IP SETUP menu, press the key_cancel.jpg key once.

b. When the TCP HOST CONNECTION OK PRESS OK prompt appears, press the key_okay-r.jpg  key  to return to the TERMINAL SETUP REQUIRED screen (or the READY screen or REINITIALIZATION REQUIRED screen).

 

Go back to Configuring Your Terminal .