Follow these steps to connect the terminal to your ECR via a USB cable and to set up the terminal to communicate with the Moneris Host using dial or Ethernet communication (with or without dial backup).
Overview setup steps:
[1] Download and install the required USB
driver to your ECR, and then connect the terminal to your ECR.
[2] Connect the iCT250 POS
hardware, and power on the terminal (follow the "Setting Up the
Terminal Hardware" procedure).
[3] Enable Semi-Integrated
mode on the terminal.
[4] Configure the terminal-to-Moneris Host
communications parameters (dynamic
IP, static IP, or dial) on the terminal (continue in the "Getting
Started" procedure at step 3).
[5] Configure the terminal-to-ECR communications
parameters (USB) on the terminal.
[6] Initialize
and log the terminal onto the Moneris Host (continue in the "Getting
Started" procedure at step 4b).
[7] Enable optional features on the terminal as desired.
[8] For information and instructions for using your semi-integrated terminal to perform:
- gift transactions
- loyalty transactions
- end-of-day steps