Configuring Dynamic Private IP Communication

If your terminal will communicate with the Moneris Host over the Moneris Private IP Network with Dynamic addressing, you will need to set up these parameters.

Before you begin you will need to know:

From the READY screen (or the TERMINAL SETUP REQUIRED or REINITIALIZATION REQUIRED prompt):

To navigate through the menus:

- Scroll down: press
the key_f1-r.jpg key to move the highlight bar down.
- Scroll up: press
the key_f3-r.jpg key to move the highlight bar up.
- Select a
highlighted item: press the key_okay-r.jpg  key.

For information about the keys...

1.  Set up the Host Parameters as "Private"

 

2. Select the Communications Type

a.  Press the key_admin-r.jpg  key.
The MAIN MENU appears.

b.  Scroll down to CONFIGURATION, and press the key_okay-r.jpg  key.
The CONFIG FUNCS menu appears.

c.  Scroll down to GENERAL PARAMS, and press the key_okay-r.jpg  key.
The GENERAL PARAMETERS menu appears.

If the SWIPE ADMIN CARD prompt appears, swipe the POS Admin card.

d.  Press the key_okay-r.jpg  key to select COMMS TYPE.
The COMMUNICATION TYPE menu appears.

e.  Scroll down to ETHERNET, and press the key_okay-r.jpg  key.
The ETHERNET SETUP menu appears.

 

3. Set up the Terminal Type as Dynamic

a.  Press the key_okay-r.jpg  key to select TERMINAL SETUP.
The TERMINAL SETUP menu appears.

b.  Press the key_okay-r.jpg  key to select TERMINAL TYPE.
The TERMINAL TYPE menu appears.

c.  Scroll to DYNAMIC, and press the key_okay-r.jpg  key.
The TERMINAL SETUP menu reappears.

d.  Press the key_cancel.jpg key twice.

e.  When the TCP HOST CONNECTION OK PRESS OK prompt appears, press the key_okay-r.jpg  key.

f.  If you are configuring the terminal for the first time, go back to "Configuring Communications."