Re-Configuring Dynamic IP Terminals for Static IP: Multiple Terminals Registered to One Base

To navigate through the menus:

- Scroll down: press the key to move the highlight bar down.
- Scroll up: press the key to move the highlight bar up.
- Select a highlighted item: press the  key.

For information about the keys...

From the READY screen:

1.  Enable STATIC for all terminals registered to the common base:

a.  Press the  key twice.  

b.  When the ENTER ADMIN CODE entry screen appears, key in 13 and press the  key.

c.  Follow one of the Configuring Static procedures (Public Internet - Static  or  Private Internet - Static) from step 2a. to  step 2c.  

2.  Take one of the terminals enabled for static in the previous step, and enter its static parameters (continue a Configuring Static procedure from step 2d. to the end of step 4.).

3.  Power off and then power on the other static terminals registered to the base.  

Note: This will allow the terminals to pick up the static parameters configured on the terminal in step 2.

4.  Do a Host Connection check for all terminals to confirm the connection:

a.  Press the  key twice.  

b.  When the ENTER ADMIN CODE entry screen appears, key in 13 and press the  key.

c.  Press the key.

d.  When TCP HOST CONNECTION OK PRESS OK appears, press the  key.