Re-Configuring Static IP Terminals: Multiple Terminals Registered to One Base

To navigate through the menus:

- Scroll down: press the key to move the highlight bar down.
- Scroll up: press the key to move the highlight bar up.
- Select a highlighted item: press the  key.

For information about the keys...

From the READY screen:

1.  Configure the new static parameters (e.g., TERMINAL ADDR, MASK ID, etc.) for one of the terminals communicating with the base:

a.  Press the  key twice.  

b.  When the ENTER ADMIN CODE entry screen appears, key in 13 and press the  key.

c.  Enter the new static parameters by following a Configuring Static procedure (Public Internet - Static  or  Private Internet - Static) beginning from step 2a. to the end of step 4.

2.  Power off and then power on the other static terminals registered to the base.  

Note: The other terminals will automatically pick up the new static parameters entered on the first terminal.

3.  Do a Host Connection check for each registered terminal to confirm connection:

a.  Press the  key twice.  

b.  When the ENTER ADMIN CODE entry screen appears, key in 13 and press the  key.

c.  Press the key.

d.  When TCP HOST CONNECTION OK PRESS OK appears, press the  key.