Base IP Setup Menu

This menu allows you to configure the Ethernet communication parameters for the communications base to which one or more terminals has been registered.  Not all functions are available for every Ethernet communication type.

The parameters and programs are listed in the order they appear on the menu.

For instructions, go to Communications Configuration and select the Ethernet communication type the terminal will be using.

BASE IP SETUP

Allows you to:

ETHERNET SETUP

Select the base type (dynamic or static), and enter the base address information depending on the base type selected.
 

DNS SETUP

Enter the base's Primary and Secondary DNS addresses (used only for static IP communication).
 

PING

Do NOT use this function unless directed to do so by the Moneris Merchant Service Centre.
 

CONNECT T-OUT

Do NOT use this function unless directed to do so by the Moneris Merchant Service Centre.
 

RETRY CONNECT

Do NOT use this function unless directed to do so by the Moneris Merchant Service Centre.
 

ERROR REPORT

Do NOT use this function unless directed to do so by the Moneris Merchant Service Centre.
 

 To navigate through the menus:

- Scroll down: press
the key_f1-r.jpg key to move the highlight bar down.
- Scroll up: press
the key_f3-r.jpg key to move the highlight bar up.
- Select a
highlighted item: press the key_okay-r.jpg  key.

For information about the keys...

 

To access the BASE IP SETUP menu, from the READY screen:

1.  Press the key_admin-r.jpg  key.
The MAIN MENU appears.

2.  Scroll down to CONFIGURATION , and press the key_okay-r.jpg  key.
The CONFIG FUNCS menu appears.

3.  Scroll down to BASE CONFIG, and press the key_okay-r.jpg  key.
The BASE CONFIG menu appears.

4.  Scroll down to BASE IP SETUP, and press the key_okay-r.jpg  key.
The BASE IP SETUP menu appears.