The Integrated Printer

A thermal printer is integrated into the iCT250 terminal. It prints black text on white, one-part thermal paper.

To order additional paper rolls...

To load a new paper roll into the terminal:

1.  Pull the printer latch up and then pull it back to open the lid.

ict250_paper-openlatch.jpg

2.  Remove the empty paper roll (if present) from the paper well.

ict250_paper-wellopen_empty.jpg

3.  Place the new paper roll into the paper well with the loose end of the roll extended towards the front of the terminal.

ict250_paper-wellopen_full.jpg

4.  Unroll enough paper to extend at least one inch (2.5 cm) past the purple faceplate.

ict250_paper-wellopen_extend.jpg

5.  Close the printer lid and press firmly on it until it snaps back into place and the extended paper securely pressed between the lid and the faceplate.

ict250_paper-finished.jpg

6.  Tear off the loose end of the paper by pulling it towards the keypad.

The printer is ready to print.