The Ethernet Setup Menu

This menu allows you to configure the Ethernet communication parameters.

Before you set up your terminal to communicate with the Moneris host over high-speed Ethernet, please review the Moneris IP Readiness Checklist (available at moneris.com/checklist) and ensure that your Ethernet service and your Ethernet network are ready to support your terminal.

The functions that appear on this menu vary according to the type of Ethernet communication you select. Not all functions are available for every Ethernet communication type.

The parameters and programs are listed in the order they appear on the menu.

For instructions, go to Communications Configuration and select the Ethernet communication type the terminal will be using.

ETHERNET SETUP

Allows you to:

TERMINAL SETUP

Select the terminal type and enter terminal address information.
 

DNS SETUP

enter the Primary and Secondary DNS addresses (used only for static IP communication).
 

PING

Do NOT use this function unless directed to do so by the Moneris Merchant Service Centre.
 

CONNECT T-OUT

Do NOT use this function unless directed to do so by the Moneris Merchant Service Centre.
 

RETRY CONNECT

Do NOT use this function unless directed to do so by the Moneris Merchant Service Centre.
 

ERROR REPORT

Do NOT use this function unless directed to do so by the Moneris Merchant Service Centre.
 

 To navigate through the menus:

- Scroll down: press
the key_f1-r.jpg key to move the highlight bar down.
- Scroll up: press
the key_f3-r.jpg key to move the highlight bar up.
- Select a
highlighted item: press the key_okay-r.jpg  key.

 

To access the ETHERNET SETUP menu, from the READY screen:

  1. Press the key_admin-r.jpg  key.
    The MAIN MENU appears.

  2. Scroll down to CONFIGURATION, and press the key_okay-r.jpg  key.
    The CONFIG FUNCS menu appears.

  3. Scroll down to ETHERNET CFG, and press the key_okay-r.jpg  key.
    The ETHERNET SETUP menu appears.