Initialization

This function sends information about the terminal to the Moneris Host and receives additional parameters and information from the Host. If you are setting up your terminal for the first time, follow the First Initialization instructions below.

From time to time, the Moneris Merchant Service Centre may ask you to re-initialize your terminal if changes have been made to your terminal or your merchant account. Follow the Re-initialization instructions below.

The handheld terminal does not need to be sitting on a base during initialization; however, it is recommended.

First Initialization

This function MUST be performed once, after completing configuration, in order to use your terminal to process transactions.

Note: Before attempting this transaction, ensure that 1) The Communications parameters have been configured  2)The terminal has been registered to a communications base.

From the TERMINAL SETUP REQUIRED (or REINITIALIZATION) prompt:

To navigate through the menus:

- Scroll down: press the key to move the highlight bar down.
- Scroll up: press the key to move the highlight bar up.
- Select a highlighted item: press the  key.

For information about the keys...

1. Press the  key.
The MAIN MENU appears.

2. Scroll down to CONFIGURATION, and press the  key.
The CONFIG FUNCS menu appears.

3. Press the  key to select INITIALIZATION.

If SWIPE ADMIN CARD appears, swipe the POS admin card.
The MERCHANT ID entry screen appears.

4. Key in your Moneris Merchant ID, and press the  key.
The PHONE NUMBER entry screen appears.

5. If you are using dial communication as default or as backup for Ethernet communication: Key in the Initialization Phone Number, and press the  key.  OR If you are using Ethernet communication without dial backup: Simply press the  key.
Wait while the terminal communicates with the Moneris Host to logon. This may take a few minutes.

If SWIPE ADMIN CARD appears, swipe the POS admin card.

Go back to "Getting Started".

Top of page

Re-initialization

The Moneris Merchant Service Centre may ask you to re-initialize your terminal from time to time.

From the READY screen:

To navigate through the menus:

- Scroll down: press the key to move the highlight bar down.
- Scroll up: press the key to move the highlight bar up.
- Select a highlighted item: press the  key.

For information about the keys...

1. Press the  key.
The MAIN MENU appears.

2. Scroll down to CONFIGURATION, and press the  key.
The CONFIG FUNCS menu appears.

3. Press the  key to select INITIALIZATION.

If the SWIPE ADMIN CARD prompt appears instead, swipe the POS admin card.

If the RETAIN CURRENT MERCH SETTINGS? prompt appears, press the key to select YES.

IMPORTANT: Do NOT select NO unless instructed to do so by a Moneris Service Centre representative.

If the MERCHANT ID entry screen appears, press the  key.

If the PHONE NUMBER entry screen appears, press the  key.

4. Please wait while the terminal communicates with the Moneris Host to logon. This may take a few minutes.

    If SWIPE ADMIN CARD appears, swipe the POS admin card.

Go back to Getting Started .

Top of page